page
48
Release 00 - 03/2018
Engine RS100 - RSC100
Service manual
14. ENGINE BLOCK - External operations
14.6. Replacing the lower compression ring of the
engine shaft (sump side)
NOTE - Before executing this operation di-
scharge all the oil from the bowl and rotate
180° the motor.
1 - Remove the blade (
26
) and hub (
27
).
2 - Take out the spline key (
28
).
3 - Use a thin screwdriver inserted under the sealing
lip to extract the oil seal ring (
29
).
4 - Make a paper tube (
30
) around the shaft to
protect the sealing lip and insert the new ring (
31
)
so that it enters its housing.
5 - Complete the insertion with the help of a pipe
(
32
) of a diameter of approximately 30-35 mm.
Tightening torques
2
Spark plug tightening torque
16-20 Nm
6
Valve cover fixing screws
7-9 Nm
13 Fan fixing nut
60-70 Nm
19
Blow-by closure plate screw
7-9 Nm
Technical information
Inlet valve clearance
0,15-0,20 mm
Exhaust valve clearance
0,15-0,20 mm
Special equipment
3
Compression testing tool
28
29
31
30
32
27
26
<< BACK >>
INDEX
