Stiga Autoclip M3, Operator'S Manual

Page: 26 / 254

24
User’s manual
EN
SECONDARY AREAS – PROGRAMMING MODE
If the area to be mowed includes secondary areas based on the definition given in the chapter “Preparation and Marking the
Boundaries of the Work Areas”, then it is necessary to program the secondary areas so the robot knows how to reach them and
how many times.
SECONDARY AREA: function for defining the automatic mowing of a secondary area.
-
Percentage: allows setting the dimensions of the secondary
area to be mowed in respect to entire lawn surface. Below is a
table to use as a guide for configuring a secondary area:
•
10% indicates a very small area.
•
30% indicates an area which is approximately one third of
the entire garden.
•
50% indicates an area which is approximately half of the
entire garden.
•
80% indicates a secondary area which is bigger than the
primary area.
•
100% the robot will follow the perimeter wire to mow the
secondary area each time it exits the charging station.
primary area
clockwise direction anti-clockwise direction
secondary area 1
(30%, 60MT, clokwise)
-
Distance: this allows setting the distance necessary for the robot to reach the internal part of the secondary area following
the perimeter wire. It is recommended to measure half the distance of the secondary area to ensure that the robot starts
working inside that area.
-
Direction: indicates the shortest direction for reaching the secondary area. The direction can be clockwise or counter-
clockwise. The robot exits from the charging station and follows the wire in the indicated direction to reach the secondary
area.
ROBOT SAFETY STOP
During use, it may be necessary to stop the robot. In normal conditions, the robot can be stopped with the “OFF” key. In case
of danger or when performing any maintenance, it is necessary to stop the robot in safe conditions in order to prevent the blade
from accidentally starting. Press the "STOP" key to stop the robot. Disconnect the power plug from the electrical outlet.
Important
The robot safety stop is necessary during
maintenance and repairs (for example, blade
replacement, cleaning operations, etc.).
To start, proceed as indicated:
-
position the robot inside the cutting area;
-
Press the ON/OFF key and wait a few seconds for the robot to
turn on completely.
-
Press the START/PAUSE key to start the work cycle.
AUTO
START / PAUSE
HOME
ALERT
AUTO
ON / OFF
STOP
“STOP” KEY (A)