21
User’s manual
EN
REMOTE CONTROL:
(only for some versions, see “Technical Speci
fi
cations).
See the instructions on the remote control / console for the pairing procedure.
SOUND:
Allows disabling the acoustic signal when the robot is in the charging station.
BACK TO RECHARGE:
Allows selecting the method for the robot’s return to the charging
station.
1.
“Follow wire”
. The robot returns to the charging station by positioning the wheels on
either side of the perimeter wire.
2.
“V-METER”
. The robot runs along the perimeter wire at an indicative distance ranging
from a few centimetres to one meter (3.2 '), touching it every now and again in the
curved sections until it recognises the “Recall” to the charging station. Refer to the
“Installation” chapter.
DATE:
Function for setting the date.
TIME:
Function for setting solar or daylight saving time.
ENTER
DATE DD/MM/YY
MON
00 / 00 / 00
WORK SCHEDULES – PROGRAMMING MODE
WORK SCHEDULE 1:
Function for setting the
fi
rst time of the robot’s working day.
The cursor automatically positions itself in the area under the
fi
rst time (e.g. 10:00am to
1:00pm). Set the time for the start and end of the work.
Setting the time at “00:00 – 00:00” means that the robot will not work during Work Schedule
1. Once entered. If the entered time is wrong such as if the time overlaps with the working
time 2 or if the starting time is after the end time, the robot beeps and resets the set value.
WORK SCHEDULE 2:
Function for setting the second time of the robot’s working day.
Important
If it is necessary to set secondary areas, then it is preferable to program
both work schedules in order to increase the mowing frequency of the
area.
ENTER
WORKING TIME
00 : 00 - 00 : 00
The setting of the time is essential for the robot’s proper functioning. Many parameters in
fl
uence the setting of the work schedules, such as the
number of secondary areas, the number and the power of batteries of the robot, complexity of the lawn, type of grass, etc. Generally, the working
hours must be increased slightly when mowing gardens with secondary areas, with lots of obstacles and complicated areas. Below is a table with
the indicative times for con
fi
guring the robot on
fi
rst use.
NB. Set all the weekdays at “1” – “Work Days.”
Model
m² (ft²)
Time 1
Time 2
400BA0
5000
(53800)
13:00 18:00
400BA0
8000
(86080)
9:30 13:00
17:00 20:30
400BA0
10000
(107600)
08:00 22:00
WEEK:
Function for programming robot work schedule during the week.
A personalised work schedule can be disabled, enabled or set for every day of the week.
Important
To get the best out of the robot, it is recommended to program the robot
to work every day.
ENTER
WORKING DAYS
M ON
T ON
W ON
T ON
F ON
S PERSONALISED
S OFF
