16
User’s manual
EN
INSTALLATION OF THE CHARGING STATION AND POWER SUPPLY UNIT
Warning – Caution
Before carrying out any operations, disconnect the robot
from the mains power.
Position the power supply unit in an area that cannot be
reached by children. For example, at a height above 160
cm (63 ").
protection
(L)
current power supply unit
(A)
transmitter
(B)
H. min.
160 cm
(63.00 ")
1.
Install the power supply unit (A).
2.
Remove the protection (L).
3.
Position the base in the prede
fi
ned area.
4.
Insert the perimeter wire (M) under the base. Position the perimeter
wire towards the left side using the holes located on the base of the
charging station, as shown in the
fi
gure.
5.
Connect the two ends of the wire to the terminals of the base.
red terminal
black terminal
perimeter wire (M)
6.
Fasten the base (N) to the ground with the pegs (P). If necessary,
secure the base with screw anchors (Q).
pegs (P)
screw anchors (Q)
charging station (N)
7.
Connect the power cord (E) of the charging station (N) to the power
supply unit (A).
8.
Connect the plug of the power supply unit (A) to the electrical outlet.
9.
If the LED of the transmitter
fl
ashes, the connection is correct.
Otherwise,
fi
nd the anomaly (see “Troubleshooting Guide”).
10.
Replace the protection (L).
current power
supply unit
(A)
power cord
(E)
Perimeter
wire
charging station
(N)
transmitter
(B)
H. min.
160 cm
(63.00 ")
protection
(L)
