EN - 30
REPLACE TRANSAXLE DRIVE
BELT
Remove Transaxle Drive Belt
1. Place unit in service position. See
2. Remove PTO belt from clutch. See
3. Under unit, slowly remove spring hook
from anchor bolt to release transaxle idler
tension. See Figure 41.
See Figure 42.
4. Remove hardware securing clutch stop
bracket to frame and remove bracket.
NOTICE:
DO NOT cut cable tie.
5. Remove transaxle drive belt from drive
system in the following order:
a. From right transaxle sheave.
b. From left transaxle sheave.
c. From clutch sheave.
Install Transaxle Drive Belt
See Figure 43.
1. Install transaxle drive belt to drive system
in the following order:
a. Around clutch sheave.
b. Around left transaxle sheave.
c. Around right transaxle sheave.
2. Align belt with idler pulley.
3. Reinstall idler spring hook onto anchor
bolt. Make sure belt has tension and is
aligned in all pulleys.
CAUTION:
Use care when re
-
leasing idler spring tension. Keep
body parts away from idlers
when performing this operation.
Figure 41
1. Spring
2. Anchor Bolt
3. Transaxle Idler
4. Transaxle Drive Belt
Figure 42
