19
Operating Instructions:
1.
Place a new brake fluid container on the fluid can holding platform. Next secure the
hold down chain to prevent can from slipping (16).
2.
Remove the large container opening and place the fluid pick-up tube (11) into the
opening. Be sure to press the seal cone (12) against the opening of the container.
3.
Connect the quick coupler (3) of the pressure hose (2) to the self purging nipple (8).
4.
Plug the power cord (4) of the unit into the proper wall outlet. (230V AC, 0,1kW,
50Hz)
5.
To insure an air free bleed run the unit for at least 30 seconds with the quick
coupler (3) of the pressure hose (2) connected to the self purge nipple (8). This
purges the air from the hose and the pump. This procedure should be performed
before every bleed job. When the unit is well purged, turn the unit off (5) and
remove the quick coupling (3) from the nipple (8). The unit is now ready to use.
6.
Connect the quick coupler (3) of the pressure hose (2) to a properly installed
master cylinder adapter.
7.
Turn the power switch (5) to the ON position. The green switch light should be
illuminated.
8.
Adjust the bleeding pressure by turning the pressure regulator knob (9) to the
recommended pressure by the vehicle manufacturer. The bleeding can now begin.
According to the vehicle manufactures procedure, bleed the system. These
instructions are to be specifically followed when working on ABS systems.
9.
Before removing the pressure hose (2) from the master cylinder adapter, relieve
the pressure by switching the unit off (5). Return the original master cylinder cover
back onto the master cylinder reservoir.
GB
