Page 15 of 41
ON/OFF HEATING
If the heating consists of on/off
(non-modulating) heating, you can
call up:
•
Today's operating hours.
•
Operating hours of the past 7
days.
•
The total number of operating
hours.
Erasing operating hours: Enter “yes”
behind “Clear running hours”.
COOLING
ON/OFF COOLING
If the cooling consists of on/off (non-modulating) cooling, you can call up the operating hours.
SOAKING
REDUCTION
RUNNING HOURS
Soaking
If the house is
not in use,
you can use the “Soaking” function (this option is only available on cooling 1). As
soon as the house status changes, “Soaking” will be switched “off” to prevent the soaking starting immediately
after you switch the house to “not in use”.
Reduction
Limiting the current cooling and to prevent that too much cold air being drawn into the house when the outside
tem1perature is low and the current house temperature is higher than the house temperature setting:
•
You can set a temperature range within which the reduction is to be active by setting a temperate difference
(relative to the “Temperature setting” cooling) at “Start reduction” and at “Reduce until”.
•
The current outside temperature is shown.
•
Setting the maximum (relative) reduction at “Reduction max.”
Running hours
If the cooling consists of on/off (non-modulating) cooling, you can call up:
•
Today's operating hours.
•
Operating hours of the past 7 days.
•
The total number of operating hours.
Erasing operating hours: Enter “yes” behind “Clear running hours”.