Page 20 of 30
ALARM CODES
Module not found
Jumper A on RTCPU is in its lower position, set jumper A to its upper position or else the changes will
not be saved.
Communication error between devices.
Communication error with WEB-485 (FramConnect)
No data from climate controllers
No ventilation (measurement = 0%).
Ventilation too low
Ventilation too high
No outside temperature sensor
Temperature sensor faulty
Pressure sensor faulty
NH3 sensor faulty
Temperature too low
Temperature too high
Pressure too low
Pressure too high
NH3 too low
NH3 too high
If no icon is linked to the alarm code, the alarm code will be shown in a red box (please contact your
supplier to report this alarm situation in order to make sure that this alarm code will be displayed
correctly in the future).
Note NEVER FORGET TO SWITCH AN ALARM “ON” AGAIN AFTER IT WAS SWITCHED OFF (e.g. in
order to remedy a malfunction). Failing to switch the alarm back on may have adverse effects for
people, animals, equipment or property.
Preferably use the alarm temporarily off function to remedy a malfunction.
1
