Stieber Clutch
Page 16/21
M1016E_0
Assembly and maintenance manual
WARNING
Risk of injury due to moving components!
Rotating driven components can cause the most severe injuries.
Therefore, during operation:
It is strictly forbidden for persons to loiter in the danger zone
or in its immediate vicinity.
Do not disable, render unusable or circumvent safety
equipment and / or safety functions.
Prior to entering the danger zone:
Switch off the power supply and secure it against being
switched on again.
Wait for lagging components to come to a standstill.
CAUTION
Risk of injury due to falling components!
The outer race or inner race can fall down if the transportation lock
has been removed.
Fasten the outer / inner race axially.
One-way clutches of Type RSXM31-RSXM101 must be checked for damage and serviced
after an operating period not exceeding 5 years.
7.1
Disassembly in case of maintenance
Procedural steps:
Loosen the fastening screws of the outer race (1)
Remove the axial retention of the inner race (2)
CAUTION
Risk of injury due to falling components!
The outer race or inner race can fall down if the transportation
lock has been removed. Therefore:
In certain cases install the transportation lock!
Pull the one-way clutch from the machine shaft. Use suitable lifting gear for this
Place the one-way clutch facing upward the label "FREE" on an assembly table
Remove the cable clip
Lift the inner race (2) including the cage (8) out of the outer race (1). Use
appropriate lifting gear at the pull holes of the inner race for this
7.2
Test criteria in case of maintenance
Procedural steps:
Pre-clean the outer race (1) and inner race including cage (8) with a petroleum-
based industrial cleaning agent and degrease with an acetone-based cleaning
agent
Check for damage, wear and cracks (see the testing criteria):
