Stieber Clutch
Page 12/21
M1016E_0
Assembly and maintenance manual
Insert the inner race (2) with cage (8) into the outer race (1) until half of the clamp
body is covered
NOTE
The assembly aid (O-ring / cable connector) must be completely
removed. Non-observance of this note can cause functional
impairment and even failure.
Remove the assembly aid (O-ring / cable connector) completely and lower the inner
race and cage completely.
Check overrunning. The one-way clutch must be able to be turned easily in the
overrun direction of rotation.
6.2 Lubrication
One-way clutches of Type RSXM31-RSXM101 do not require any lubrication in overrun
operation above the lift-off speed as they operate without contact.
Similarly, no lubrication is required in lockout operation as only a minimal degree of rolling
motion in the clamp bodies occurs.
Additional lubrication is required if the one-way clutch runs with frequently repeated or
permanent working cycles below the lift-off speed. To this end, a lubricating film, which coats
the clamp bodies and tracks of the outer race, is mandatory. The lifetime is limited under
these operating conditions!
6.2.1 Operation with oil lubrication
An oil mist is sufficient for mounting inside a gear box.
If the one-way clutch runs with frequently repeated or permanent working cycles below the
lift-off speed, splash lubrication or oil supply between the cage and the outer track is
necessary. The lifetime is limited under these operating conditions!
The oil volume which is necessary for splash lubrication depends on the surrounding
construction.
Figure 5: Clamp bodies “after lift-off”
Figure 4: Clamp bodies “neutral position“
