INsTALLATIoN
Safety
20
| WSH 10 | WSH 20
www.stiebel-eltron.com
INsTALLATIoN
7. Safety
Only qualified contractors should carry out installation, commis-
sioning as well as maintenance and repair of the product.
7.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the product
are used.
DANGER Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
!
Damage to the appliance and environmental pollution
Drain the system when there is a risk of frost.
Note
To meet the required sound levels, install a pressure re-
ducing valve in the main line if the supply pressure is
more than 0.6 MPa.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
Note
Water line pressures must be the same for domestic hot
water and cold water.
8. Product description
The sensor tap is connected via two flexible pressure hoses with
dirt trap. A non-return valve has been fitted into the tap body.
8.1 Standard delivery
The following are delivered with the product:
- Power supply unit for WSH 10
- Battery for WSH 20, 1 x CR-P2 6 V (installed)
- 2 connection hoses
- 2 strainers
9. Preparation
9.1 Installation location
Installation example:
850 - 900
D
00000
77
12
4
10. Installation
!
Damage to the appliance and environmental pollution
Refer to the operating and installation instructions for the
DHW appliance. Only use aerators that are permissible
for the DHW appliance.
Note
Make sure that the hoses are not kinked during installa-
tion and that the electrical connection is not damaged.
13
D
00000
77
54
8
