уСТАНОВкА
Монтаж
76
| CNS Trend | CNS Trend U www.stiebel-eltron.com
10.6 Электрическое подключение
ПРЕДУПРЕЖДЕНИЕ поражение электрическим
током
Любые работы по подключению и электромон-
тажу необходимо выполнять в соответствии с
правилами конкретной страны и региона.
ПРЕДУПРЕЖДЕНИЕ поражение электрическим
током
-
При неразъемном способе соединения
устройство должно отключаться от сети с
раствором всех контактов не менее 3 мм.
-
Установка со стационарно проложенным ка-
белем не допускается.
Указание
-
Следует соблюдать данные на заводской та-
бличке. Напряжение сети должно совпадать с
указанным на табличке.
-
Для подключения заказчик должен обеспечить
провод соответствующего сечения.
Указание
при использовании прибора не в быту, а также с
очень значительными нагрузками, например, в
режиме постоянной эксплуатации, прибор реко-
мендуется устанавливать с неразъемным подклю-
чением к приборной розетке.
Стационарное подключение к розетке подключения
устройства разрешается выполнять только квалифициро-
ванным электрикам.
ПРЕДУПРЕЖДЕНИЕ поражение электрическим
током
-
При подсоединении к розетке подключения
устройства обеспечить необходимое растя-
гивающее усилие.
-
Проверить подключение прибора к защитно-
му проводу.
-
Закрыть укороченные концы кабеля над-
лежащим образом с помощью кабельных
гильз.
10.6.1 Модельный ряд CNS Trend
прибор поставляется готовым к подключению. Допустимы
следующие варианты электрического подключения:
CNS 50-300 Trend
подключение посредством штепсельной
вилки к свободно доступной розетке с защит-
ным контактом
X
Неразъемное подключение через приборную
розетку с заземлением
X
-
при подключении через розетку убедиться, что после
установки прибора доступ к розетке будет свободным.
-
при неразъемном подключении использовать кабель
питания минимальной длины и подключать прибор
напрямую к приборной розетке. при этом следует
убедиться, что длина кабеля будет достаточной для
монтажа устройства на стену.
10.6.2 Модельный ряд CNS Trend U
прибор поставляется с кабелем питания без вилки.
f
при неразъемном способе соединения четырехпрово-
дной кабель следует подключить к розетке, как показа-
но на рисунке:
1
2
3
4
1
2
3
4
D
00000
68
12
3
1 нулевой провод =синий
2 токонесущий провод = коричневый
3 защитный провод = желто-зеленый
4 провод линии управления = черный
Для подключения прибора можно использовать три
варианта:
- подключение прибора без управляющего провода
управление прибором не осуществляется. линия управле-
ния не подключается. В таком случае следует заизолиро-
вать провод линии управления.
- Снижение температуры посредством
управляющего провода
Для снижения температуры до заданного значения чер-
ный управляющий провод получает сигнал управления от
внешнего электронного устройства (например, таймера).
- Подсоединение управляющего провода к внешнему
блоку управления
прибор можно подключить к любому внешнему блоку
управления, подающему сигнал управления представлен-
ных ниже форм.
команда
показания осци-
лоскопа
Режим работы Температура нагрева
Нет питания
комфортная
температура
Согласно настройке
комфортной темпе-
ратуры
полнопериод-
ное колебание
230 В
Ночной
режим
Согласно настройке
снижения темпера-
туры
полупериод,
отрицатель-
ный -115 В
защита от за-
мерзания
Температура режима
антизамерзания
полупериод,
положитель-
ный +115 В
Стоп
Отсутствует
полный пери-
од 230 В, 3 се-
кунды
комфортный
режим -1 °C
На 1 °C ниже настрой-
ки комфортной тем-
пературы
полный пе-
риод 230 В,
7 секунд
комфортный
режим -2 °C
На 2 °C ниже настрой-
ки комфортной тем-
пературы