EN
GL
ISH
www.stiebel-eltron-usa.com
Scale TAC-ler Plus |
3
SPECIAL INFORMATION
2.1 Key components parts list
1 Housing cap [x1]
2 Pressure relief button [x1]
3 Mounting bracket [x1]
4 O-ring [x1]
5 Housing sump [x1]
6 Spanner Wrench [x1]
7 Small parts bag (not shown), containing:
Mounting bracket lag bolts [x4]
Pan-head screws [x4]
Large Washers [x8]
Small Washers [x4]
3. Operating conditions
The following list provides guidance on the conditions required for
successful operation of your Scale TAC-ler Plus system. Use of this
equipment outside of these operating conditions may adversely
affect the performance of your system, damage the TAC media,
result in system damage including water leaks and resulting prop-
erty damage, and may void your warranty.
It is very important to note that the presence of elevated levels
of chlorine, iron, manganese, hydrogen sulfide, copper, and cer-
tain other contaminants can damage the TAC media, reducing
its effectiveness and shortening its life. Water exceeding any of
the following levels should be pre-treated to reduce contaminant
levels below the stated level:
Scale TAC-ler Plus
Optimal hardness level for treatment
0.4-1.8 gpg (7-30 mg/l)
Max. treatable hardness level
75 gpg (1,283 mg/l)
pH range
6.5 to 8.5
Chlorine max.
3 ppm (3 mg/l)
Hydrogen peroxide max.
0.5 ppm (0.5 mg/l)
Iron max.
0.3 ppm (0.3 mg/l)
Manganese max.
0.05 ppm (0.05 mg/l)
Copper max.
1.3 ppm (1.3 mg/l)
Max. water temperature
110°F (43°C)
Recommended pressure range
15 to 80 psi (1 to 5.3 bar)
Hydrogen sulfide (H
2
S), polyphosphates, and oils must be removed.
Do not allow TAC media or the water in your Scale TAC-ler Plus system to freeze.
MATERIAL LOSSES:
Confirm that your water conditions meet the operating
conditions above before commencing the installation
process. If in doubt, call your dealer for advice.
