Vehicle Scanner VS6400
Rev.E
3
1
2
Installation and Connections
!
Warning!
STI scanners are not designed for
and must not be used for personnel protection (safety)
applications. STI has a wide range of safety products for
these applications. Contact STI for information on our
safety products.
Thank you for purchasing an STI Vehicle
Scanner.
These items are included with the scanner.
■
■
Transmitter
■
■
Receiver
These items are required but ordered
separately.
■
■
Transmitter cable
■
■
Receiver cable
You will need an IBM compatible PC for
software setup of the scanner unless you use
the factory default settings.
!
Warning!
Installation and maintenance must
be performed by qualified personnel.
M
OUNTING
THE
T
RANSMITTER
AND
R
ECEIVER
Mount the transmitter and receiver parallel
to each other, with no vertical nor horizontal
offset, and with their connectors pointing in the
same direction. See Section 10 for mounting
dimensions.
T
RANSMITTER
AND
R
ECEIVER
C
ABLES
Connect the scanner as shown in the
diagram. RS-485 connections are optional.
Conncect the shield on both the transmitter and
receiver cables to protective earth (ground).
A
LIGNMENT
Apply power to the scanner and align the
transmitter and receiver until the green LED on
the receiver turns on.
2
7
1
6
3
8
5
4
2
7
1
6
3
8
5
4
Power
+24
0V
Brown
Blue
White
Pink
White
Pink
Green
Red
Gray
Yellow
Sync Signal
Transmitter
Receiver
RS485
Out 1
Out 2
1
2
3
4
5
6
7
8
Female Connector
Front View
Brown
Blue
Figure 1 VS6400 Connection
Section1 – Introduction
Introduction
