6
ASSEMBLE INSTRUCTIONS
STEP 6
a. Loosen the
Screw (M3x10mm)
(79)
at the bottom on the
console by using the
combination wrench to open the
Battery Door (16).
b. The
Console (13)
operates with
FOUR
AA rechargeable
batteries, four batteries are
included in the hardware box.
c. Install rechargeable batteries into the
Console (13).
Make sure the location of positive or negative battery terminal is correct.
d. Attach the
Battery Door (16)
onto the back of the
Console (13
) and secure with the
Screw (M3x10mm)
(79).
STEP 7
a.
Connect the
Lower Pulse Sensor Wire (115)
to the
Middle Pulse Sensor Wire (114B).
b.
Remove the
Lock Washer (M8)(78)
and
Bolt, Button Head (M8xp1.25x16mm) (90)
from the
Upright
Post (5).
c.
Insert the
Handlebar (6)
into the
Upright Post (5)
and secure with the
Lock Washer (M8)(78)
and
Bolt,
Button Head (M8xp1.25x16mm)(90)
on each side as the drawing shown.
CAUTION:
Be careful not to damage wires
during assembly.
STEP 8
a. Connect the
Upper Pulse Sensor Wire (113)
to the
Middle Pulse Sensor Wire (114).
b. Connect the
Upper Connection Wire (109)
to the
Middle Connection Wire (110).
Note the number of wire pin should be the same for both wires to connect with as the illustration shown below
STEP 9
Place the
Console (13)
onto the
Upright Post (5)
and secure with the
Screw, Round Head
(M5xp0.8x15mm)(83.)
STEP 10
Attach the
Console Lower Case (15)
to the
Console (13)
and secure with the
Screw, Round Head
(M5xp0.8x15mm)(83.)
CAUTION: The machine is suitable for
Nickel-Metal Hybird / NI-MH
rechargeable batteries
only. General or other types of batteries are not allowed to use.
Summary of Contents for PR-7001
Page 33: ...32 PRODUCT PARTS DRAWING ...
Page 34: ...33 ...
