Visionary Medio
7
5 From under the unit, remove the two nuts and washers from the studs at each end Retain the hard-
ware for later reuse in installation Refer to Figure 3
Note:
In the figure, the end plate is not shown You do not need to remove the end plate
6 Lift the case straight up to avoid contact with screen material Place the case adjacent to the screen
assembly on the sawhorses Refer to Figure 4
7 Check the shipping container and remove the control system (if provided)
8 Replace the screen assembly into the shipping container for protection prior to final installation
Leave the foam batten interlock blocks in place until the screen assembly is installed in the case
PREPARING THE INSTALLATION (CONTINUED)
Nuts and
washers to
remove
Case
Lift case
straight up
Screen assembly
Figure 3: Unit end
Figure 4: Case lifted before being placed adjacent to screen assembly
Nuts and
washers to
remove
Case
Lift case
straight up
Screen assembly
Figure 3: Unit end
Figure 4: Case lifted before being placed adjacent to screen assembly
