Visionary Medio
15
ADJUSTING THE SCREEN EXTENSION
i
i
CAUTION
Improper adjustment of the limit switches can cause irreparable damage to the screen itself, resulting
in voiding the factory warranty
The extension and retraction limit switches have been preset at the factory In general, we advise you
to avoid readjusting these switches In some cases, to enable proper alignment of the displayed image
on the screen, you may need to adjust the extension of the screen If adjustment to the extension is
necessary, carefully follow these instructions
WARNING!
The screen is fully retracted when the batten is flush with the bottom of the case Do not attempt
adjustments with the yellow retraction (UP) limit switch that will further retract the screen Incorrect
adjustment of the switch will cause severe screen damage Please consult the factory if you have
any questions
MODIFYING THE EXTENSION OF THE SCREEN
You can increase the extension of the screen up
to 3” (7 6 cm) past the factory preset stop, or you
can decrease the extension by approximately
4-6” (10 - 15 cm) from the factory preset stop
Do not attempt to modify the screen extension
beyond these recommended amounts
The limit switches are located on the left side of
the screen roller tube inside the case, as shown in
Figure 11
To increase the screen’s fully extended (screen
down) stop position:
1 1Lower the screen to its current stop position
2 Locate the white extension (down) limit
switch located on the left side of the screen tube Use a hex head or an electrician’s style screw-
driver (with a minimum 6-inch / 15 cm blade) Turn the switch in a counterclockwise direction If the
power is on, the screen will drop incrementally as the switch is turned
Figure 11: Underside view
Screen
Limit Switches
