Stewart Filmscreen
– Cabaret
23
LED CONTROL SYSTEM (IF EQUIPPED)
_____________________
Cabaret can be optioned with a state of the art LED system which can be controlled with a standard
IR remote via an inboard IR receiver (see figure 26) or an 11-button IR digital keypad (optional)
(see Figure 29). On the audience right, you will find the ILC (Intelligent Lighting Control) control
board
(see Figure 27) which communicates directly with the IMC that is already onboard to control
the screen (see Figure 18). You may visit StewartFilmscreen.com for a full list of IR Hex codes if
you want to program the IR for the LEDs to another remote. If you are adding the ILC after the fact,
be sure to connect the IMC on PORT
– 1 from the ILC on PORT – 1 (see Figure 34) using CAT V
Converging Systems manual for more information on the ILC
GETTING STARTED
Making the Connections
If an IR receiver is optioned at the time of
purchase, then the receiver will be pre-installed at
the factory. No further connections need to be
made by the customer or installer. Simply plug in
the power and use the supplied handheld remote
to operate the LEDs.
Note:
Cabaret may come with one RJ25 male
output (if equipped). The maximum length of the
RJ25 cable plugged into the unit shall not
exceed 50’ (see Figure 28).
Any home automation system needs to plug into
the IMC’s PORT – 0. No connection to the ILC
is necessary.
Figure 26:
IR remote and receiver
Figure 27:
ILC control system on
audience right
LED strip
Power cord
Figure 28:
Rear, audience right of case with
power cord, RJ25 output (if equipped) and
LED strip inside case under the acrylic-glass
top
RJ25 accessory
plug (if equipped)
