Stewart Filmscreen
– Cabaret
12
PLASMA MOUNT
Professional mounting techniques should be used. Stewart Filmscreen cannot be liable for
substandard or faulty installations.
Failure to comply with the instructions and guidance
contained in this manual may result in voiding your warranty
.
1. Identify the location of wall studs where you can
secure the plasma mounts.
2. Use a level to accurately position the plasma mounts
on the wall (see Figure 10), and make certain that
both wall mounts are within 6 inches from either
edge of the case. This will prevent the case from
tilting to either side.
3. Drill holes through the plasma mounts into the studs.
4.
Use 3 ½” screws to secure the wall mounts to the
wall studs.
Note:
a.
These are heavy units. Plasma mounts
must be mounted to at least one wall stud per mount or to a continuous plywood
sheath below the surface treatment (see Figure 11).
b.
Check to make sure the wall mount is level.
5. Carefully lift and hook the channels on the back of the housing onto the plasma mounts. Add the
¼
”-20 set screw onto the plasma mount to prevent unwanted movement (see Figure 12).
6. For the minimum clearance dimensions, (see figure 13).
⚠
CAUTION
Be careful not to touch or scratch the viewing surface.
Ensure that the wall surface is level and free of undulations. Use shimming if
necessary.
Figure 10:
Plasma mounts
leveled and attached to two
wall studs
Figure 11:
Plasma mount mounted
with cover sliding on
Set screw
for plasma
mount
Figure 12:
Back part of
case hanging off plasma
mount