FLX-E Operations Manual Rev F
Page 12
Table of Contents
Top
COM pin.
Do not connect to both the 70V and 100V terminals at the same time.
With a small, flat-blade
screwdriver, tighten the screw until the leads are held securely in place. Inspect for possible shorts or
broken wires.
NOTE: Class 2 wiring must be used on the speaker terminals to comply with UL requirements.
CAUTION: Do not connect either speaker terminal to ground. This will cause a short circuit which
may damage the amplifier, speaker, or both.
CAUTION: The speaker terminals represent a shock hazard as they carry 70.7V and 100V when
driven with an audio signal. Disconnect the amplifier from the AC power source when working on
these terminals.
7
FLX-E Application (DSP and System Configuration)
The FLX-E application allows the user to configure the internal DSP, to set various amplifier parameters, and
to receive amplifier status information via a network connection. This application is available for Windows
operating systems from
Note that up to a total of 10 instances of the FLX-E
application plus IP-based controllers can connect to each FLX-E amplifier simultaneously; however, if
more than one instance of the application program makes changes to the DSP values, the individual
device screens will lose synchronization. Synchronization is restored when the device screen is closed
and reopened.
7.1
FLX-E System Status Screen
When the FLX-E Application is launched, the
application automatically discovers all FLX-E Series
devices on the network and populates the System
Status screen. Selecting the Program and System
drop down menus provide options described below.
The refresh button causes the application to poll
and recreate a list of all FLX-E Series devices on the
network. This list includes the IP address of the control port (note that the control port is different from
the Dante audio port, and may be either on the Dante audio network, or on a separate network), MAC
address, host name (FLX-E), device name, model, firmware version, and operating status of the device. To
connect to a specific device, double-click anywhere along that device row.
7.1.1
Program Drop-down Menu
There are two selections on the Program drop-down menu. The About option provides the version
information for the application. The Exit option exits the application.
