Final Assembly Cont.
Electronics Installation Cont.
76.
Connect the motor lead to the socket on the receiver board. Orient the lead so that the
black wire is
nearest
the receiver clip in the
center
of the board.
The Little Details
77.
If desired, cover the
bottom
of the fuselage to hide the push-rod access.
78.
Position the Headrest on the Turtle Deck as shown on the plan, aligned with the center
stringer. Bond to the turtle deck by wicking medium CA along the base of the headrest,
using a fine glue tip.
79.
Position the pre-cut acetate Windscreen as shown on the plan and mark where the two tabs
at the bottom of the windscreen contact the fuselage deck. Use the point of a sharp hobby
knife to slit the deck at these marks, angling the knife back to match the approximate angle
of the windscreen. Press the tabs on the Windscreen into the slits until the base is flush
with the deck. Wick a drop of medium CA along the base of the Windscreen and mounting
tabs to secure.
80.
Position the dummy Cylinder Heads on either side of the nose, where indicated on the plan
and the “Engine Detail”. Bond by wicking medium CA
under
and along the base of each
cylinder head.
Finish Control Surfaces
81.
Refer to the Tape Hinge Diagram on the plan sheets, and connect the Elevator and rudder
to their stabilizer surfaces with narrow strips of clear tape. Tape the Elevator on
top
, and
the Rudder on the
left
side.
82.
Fit and bond a control horn to the slot in the Tail Skid, extending from the
right
side of the
Rudder.
Build Instructions
SE5.a UM Build Instructions. © 2013 Stevens AeroModel all rights reserved.
!
Page 28
□
□
□
□
□
□
□
