Build Instructions
Fuselage
Fuselage parts are designated with the letter “F” followed by a number. Parts have been numbered so
that the fuselage assembly follows a sequential order: F1 to F32.
Note:
When initially bonding parts, use a single, small drop of medium CA glue, applied sparingly with a
CA glue applicator tip to “tack glue” the part in place. Should you commit an error in assembly, it will be
easier to recover from the mistake and remove or correct the part in error, if you do not soak the assembly
with glue after each step! This method of assembly will allow our interlocking design to do its job.
As each successive part is installed within the fuselage, it will help pull the entire structure square and
true. When a major assembly is completed, revisit all joints and bond completely. Do not use excessive
amounts of glue, as this only adds weight to the model.
1.
Central Crutch -
Lay F1a (sheet 01/10, 1/16 in. balsa) on the work surface with the etched
side facing
up
. Fit and bond F1b (sheet 01/10, 1/16 in. balsa) to the rear of F1a.
2.
Pylon Pocket: Lay both F2’s (sheet 02/10, 1/16 in. balsa) on the work surface with the
etched sides facing
up
. Fit and bond one F3 (sheet 01/10, 1/16 in. balsa) to the slot in the
center of each F2.
3.
Fit the F2/F3 assemblies to the slots in the
front
portion of F1, oriented so that the arrows at
the
front
of each F2 point to the
front
of F1.
Do not bond!
4.
Slide F4 (sheet 03/10, 1/16 in. balsa) between the F2’s oriented so that the arrow at the
front
of F4 points toward the
front
of F1/F2.
Tip:
Use a wide length of 1/16 in. thick balsa,
as a push stick, to reach within the saddle cut at F4 and assist in seating this part between
F2 and flush with F1.
Do not bond!
5.
Fit former F5 (sheet 01/10, 1/16 in. balsa) to the slots in F1 at the rear of the pylon pocket,
and to the tabs at the
rear
of F2/F4.
6.
Fit former F6 (sheet 02/10, 1/16 in. balsa) to the
front
of the assembly. Bond all parts with
CA.
Make sure that no glue enters the pylon pocket itself!
7.
Turn the assembly up side down. Fit and tack glue former F7 (sheet 02/10, 1/16 in. balsa)
to the slots in F1 immediately
below
former F5.
Ace (100)
- Build Instructions © 2017 Stevens AeroModel, all rights reserved.
Page 8
□
□
□
□
□
□
□
