Build Instructions
Fuselage
(continued)
24. Fit F22 to the
bottom
of the fuselage assembly. Bond F22 where it meets the fuselage
sides, F21 of the landing gear pocket, and formers F7 and F17, with CA.
25. Fit and bond F23 (sheet 01/10, 1/16 in. balsa) to the fuselage bottom,
forward
of the landing
gear pocket.
26.
Nose -
Slide F24 (sheet 08/10, 1/8 in. balsa) onto the long tabs on F12 and both F14’s until
it is
flush
against the
front
face of former F15. Bond with CA.
27. Just as in step 26 above, slide F25 and F26a (sheet 08/10, 1/8 in. balsa) onto the tabs,
bonding with CA. Remove the tabs on each side of F26a.
28. Position F26b (sheet 08/10, 1/8 in. balsa) over F26a, aligning the edges of part F26b with
the edges of part F26a. Bond F26b to F26a, then remove the tabs on F26b.
29.
Upper Fuselage -
Fit former F27 (sheet 01/10, 1/16 in. balsa) to the two slots just in
front
of
the large opening in the
rear
of F1.
Ace (100)
- Build Instructions © 2017 Stevens AeroModel, all rights reserved.
Page 14
□
□
□
□
□
□
