Build Instructions
Pylon
80. Apply a slow setting glue to the sides of the pylon base, then immediately slide it into the
slot in the fuselage, oriented so that the
front
(straight) end of the pylon points
forward
.
Apply a small bead of medium CA on both sides of the pylon where it meets the fuselage.
Landing Gear
81. Bend the landing gear wire over the pattern on the detail sheet using the 12 in. length of .
032 in. wire supplied in your kit. Proceed carefully, as accuracy is critical for a proper fit.
82. Mount the supplied wheels onto the wire. Bend the ends of the axles
up
90 degrees, and
trim off the excess wire.
83. Slit the covering over the landing gear slot, and press the landing gear into the slot, followed
by part LG (sheet 09/10, 1/32 in. ply). Make sure that LG is fully seated, flush with the
bottom
of the fuselage. Wick CA along the landing gear pocket and the points where the
wire exits the pocket to secure the landing gear.
84. Slit the covering over the slot at the
rear
of the fuselage bottom. Press the tail skid TS
(sheet 09/10, 1/32 in. ply) into the slot, and bond with medium CA.
Motor Installation
85. Mount the propellor (EFL9051) by twisting it onto the threaded portion of the prop shaft until
fully seated.
Ace (100)
- Build Instructions © 2017 Stevens AeroModel, all rights reserved.
Page 30
□
□
□
□
□
□
