4
5
iNStaLLatioN
Step 3 – poWeriNG tHe HaND Dryer
Warning:
Work on electrical installations may only be carried out by
certified electricians or by instructed persons working under the guidance
and supervision of a certified electrician, in accordance with local
regulations.
Important Note:
SWAR is available only as a 110 volt model or
a 220 volt model.
To power the hand dryer, a certified electrician
must remove the dryer unit cover and hardwire it to
the main power line.
To remove the dryer unit cover, remove the two
Allen screws with the included Allen key.
Warning
For installation of the SWAR hand dryer system, follow the directions below.
iNStaLLatioN
Step 1 – WaLL moUNtiNG
1
Firmly attach the wall support to the
wall.
Note: Ensure the wall support is
installed leveled.
Screws not uncluded.
2
Place the SWAR unit on the support.
make sure to pass the electrical wire(s)
and valves through the holes in the
SWAR.
3
Secure the SWAR cabinet to the wall
by installing the masonry anchors and
screws provided.
Step 2 –coNNect tHe Water SyStem
For SWAR with cold water option:
connect the water system to inlet B1
B1
B2
For SWAR with premixed water option:
connect hot water system to B1 and cold water
system to B2
Notes:
Thoroughly flush the water supply lines before connecting them to the SWAR.
Do not allow dirt, Teflon tape or metal particles to enter the faucet.
Shut off water supply when done.
IMPORTANT:
Water and electrical supplies should be kept OFF throughout the entire
installation.
Note: Before installing the SWAR, flush water lines and shut off all valves.