10
11
maINTENaNcE
filter cleaning instructions
This tap is provided with a stainless steel filter preventing foreign particles to enter the
lines. If the water flow has decreased, this may be because the filter is clogged. The filter
can be cleaned as follows:
1. Shut-off the water shut off valve.
2. Disconnect the water supply pipe from the adaptor and disassemble the filter from it.
3. Wash the filter under running water.
4. Reassemble the parts.
5. Restore the incoming water supply.
6. Make sure that there is no water leakage.
care and cleaning of chrome and special finishes
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives, or the like.
Use of any prohibited cleaning or maintenance products or substances could damage the
surface of the faucet. For surface cleaning of faucet use ONLY soap and water, then wipe
dry with clean cloth or towel. When cleaning bathroom tile, the faucets should be protected
from any splattering of harsh cleansers.
If system chemical disinfection is practiced, chlorine can be used (calculated chlorine
concentration of 50mg/l maximum in water per one hour dwell time) at service interval
frequency.
sETTINGs aDjusTmENT
delay In tIme:
It is recommended to change the delay in time for
flush valves for urinals or toilets only.
If required, the delay in time can also be modified in faucets as
follows:
Press the IN button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the delay in time
and – to reduce it.
delay out tIme:
This button allows modifying the water flow time
after the user removes his hands from the faucet. A delay out time
close to 0 will save more water. An increased delay out time will make
the user experience more comfortable.
If required, the delay out time can be modified as follows:
Press the OUT button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the delay out time
and – to reduce it.
24 houR hygIene Flush:
This model includes a 24 hours hygiene
flush which is disabled. To activate the hygiene flush, press the clock
button. Wait until a quick flashing of the LED in the sensor eye is
perceived. Then press + to activate the hygiene flush. To disable it
again, press – to deactivate it.
comFoRt Flush: I
f your model includes a Comfort flush setting, it can
be activated by pressing the flush button.
When the button is pressed, one blink of the LED in the sensor eye is
perceived. The pre-programmed flush cycle will take place then.
The Comfort flush cannot be interrupted or deactivated by pressing any
button until it is over.
temPoRaRy oFF FunctIon:
This function is ideal to perform any kind
of activity in front of the sensor without operating the system (for
example, cleaning).
The faucet will remain shut for 1 minute when this button is pressed
once. To cancel this function and to return to normal operation press
the On/Off button again or wait 1 minute.
Reset button:
This function restores all the factory settings except
for the sensor range. If required, press the Reset button and without
releasing it, press the + button once.
NoTE:
to enter the self adjusting mode, use the adj button. to change the sensor
range, use the Range button.
Summary of Contents for Extreme CS B
Page 10: ......
