ON A STAND WITH CASTERS
When installing the Steamer(s) onto a Steamer Stand with casters, follow the directions provided with the Stand
to ensure proper installation of the support brackets prior to mounting the Steamer(s). When proper installation
of the support brackets is verified, lock the two locking casters located on the front of the Stand by pressing the
lever to the lock position prior to bolting the Steamer(s) to the support brackets on the Stand using the hardware
provided with the Stand.
The installation shall be made with a connector that complies with the standard for connectors for moveable gas
appliances; ANSI Z21.69 · CSA 6.16, and a quick-disconnect device that complies with the standard for quick-
disconnect devices for use with gas fuel, ANSI Z21.41 · CSA 6.9.
Adequate means must be provided to limit the movement of the appliance without depending on the connector
and the quick-disconnect device or its associated piping to limit the movement. The location where the restraining
device may be attached to the appliance shall be in accordance with Sterling specifications for the device.
EXAUST HOOD REQUIREMENTS
Install and operate this gas appliance in a well ventilated area. Adequate air must be supplied to replenish air used
for combustion. Installation must conform to local codes and/or with the National Fuel Gas Code, ANSI Z223.1/
NFPA-54 (latest edition) or the National Gas and Propane Code CSA B149.1 as applicable.
Do NOT restrict the flow of air for combustion and ventilation. Do NOT obstruct the flue cover or control side vents
after installation.
GAS SUPPLY
Observe the following precautions in addition to the posted instructions:
• Do NOT light or start any appliance.
• Do NOT touch any electrical switch.
• Do NOT use any phone in the building.
• Immediately call the gas supplier from a phone away from the building.
• Follow the gas supplier’s instructions.
• If the gas supplier cannot be reached, call the fire department.
WARNING: When using a stand equipped with casters, the floor must be level and flat. Failure
to have a Stand with casters on a level surface can result in a “TIPPING” hazard that could result
in serious injury.
!
INSTALLATION
!
DANGER
GAS LEAKS ARE FIRE AND EXPLOSION HAZARDS.
INJURY, DEATH AND PROPERTY DAMAGE WILL RESULT.
If anyone smells gas, or suspects a gas leak, immediately refer to the posted gas leak
instructions. The posted instructions are provided by the local gas supplier and supersede any
other instructions.
STERLING MANUFACTURING, LLC
SMCD - IOMSPG100318
3
STEAMER
