34
Sterling Elite
2
XS-RS-Plus
7.4 cHArGiNG SocKet:
WArNiNG!
The charging socket should only be used for
•
connecting the
scooter battery
charger plug to the
scooter.
The charging socket should not be used to supply
•
power for any other device.
Connection of unapproved electrical devices may
•
damage the control system or compromise the EMC
performance of the scooter.
Always put the socket cover back over the charging
•
socket when the battery charger plug has
been removed.
(Fig. 7.4.1)
Please see section 9.0 for more details about charging.
7.5 ProGrAMMiNG SocKet
When the scooter leaves the factory, the parameters of
the controller are set to accommodate most driving styles
and preferences. However the scooter control system is
very versatile and will allow certain functions to be
reprogrammed.
If required, the programming socket. (Fig. 7.5.1), will
enable an approved Sunrise Medical authorised dealer to
reprogramme your scooter.
Your approved Sunrise Medical authorised dealer can
also gain useful service information via the programming
socket, from the scooter’s on board diagnostics facility.
To programme the controller a special programming
device is required, (handheld or PC software), which is
available to your Sunrise Medical authorised dealer.
DANGer!
Programming the scooter is only allowed via
•
authorised personnel trained by Sunrise Medical.
Incorrect controller settings could cause driving
•
outside the safe limits and could result in damage or
injury.
Fig.7.5.1
Note:
Sunrise Medical does not accept responsibility for
damages / injuries which result from unexpected
movement or stopping of the scooter due to inappropriate
programming or unauthorised use of the scooter.
7.6 oPerAtiNG tHe coNtrolS
If you are new to driving a scooter, it is a good idea to
practice in a clear, safe space on a sound level surface.
Put the key in its slot, but do not turn the scooter on.
Board the scooter by following the instructions in section
4.18.
7.7 bASic DriviNG elite
2 -
XS, rS AND PlUS
Make sure you are properly seated and can comfortably
reach all the controls on the scooter.
Set the speed control to its lowest speed.
1.
Turn the key clockwise (90 degrees) to turn the
2.
scooter on.
On the tiller, gently operate the Control lever or Wig-
3.
Wag as described earlier, (7.1.2 for the wigwag and
7.2.2 for the side control lever). You will gently
accelerate. Release and you will gently stop. Practice
these two basic functions until you get used to them.
Steering the scooter is easy and logical. Just be sure
4.
to remember to get wide clearance when turning so
that the rear wheels clear any obstacle.
Short-cutting a pavement corner can cause the back
5.
wheel to go off the pavement, causing problems, if the
corner is very rough. Avoid this at all times by steering
an exaggerated curve around the obstacle.
When steering in a tight spot, such as entering a
6.
doorway or when turning around, stop the scooter
and then turn the handlebar to where you want to go,
then apply power gently. This will make the Elite turn
tightly. It is also recommended that the pre-set speed
is set to a slower setting to aid control in tight spots.
DANGer!
Reversing requires extra attention as the field of vision is
restricted.
elite
2
rS, XS
Using the right thumb or left fingers to operate the Wig-
Wag will reverse the scooter.
Fig.7.4.1
