202558
COVANA III ‐ Revision 5
17
**NOTE: If your install requires the non-permanent mounting plates to be installed do this
BEFORE installing the seal to ensure proper alignment. **
1.
Cut four 5” pieces of seal and place them on the corner of the hot tub before lifting the
roof in place as per the installation instructions.
2.
When the complete Covana assembly has been performed,
lift the roof using the key switch and remove the temporary
seal sections. Lower the roof, walk around the entire hot tub
observing where the white inside shell makes contact with
the hot tub. This will determine the best location to apply the
seal.
3.
Ensure the tub edge is completely dry.
4.
With the roof elevated apply the seal clips provided, to the
tub in the predetermined area for the seal. The ideal location
for the seal is closer to the inside/water edge.
5.
Install the seal starting at motor end with the adhesive layer
pointing up towards the roof.
6.
NOTE
– At this stage if the ambient air temperature is below
32
⁰
F (0
⁰
C) then a temporarily heater should be placed inside
the tub for 10-15mins. When the heater is in the tub bring
down the roof until it touches the seal to increase the air temperature. After 10-15mins
remove the heater and continue with the seal installation.
7.
TEST
- By lowering the roof again to ensure that the seal makes contact with the entire
perimeter. If satisfied elevate the roof, remove the red plastic backing of the seal and
lower the roof to the seal.
8.
Let the roof rest in this position for two minutes to ensure proper seal to roof adhesion.
Important-
Now elevate the roof
no more than an inch
and let the roof rest again for a
short period as this will allow the seal time to slowly and fully release from the seal
clips, if not a dull tool can be used to help the seal release.
Once satisfied that the seal is released, elevate the roof and remove the seal clips from
the tub edge.
Lower the roof and verify again for proper seal.
ASSEMBLING THE COVANA PART III - APPLYING THE SEAL
Summary of Contents for COVANA
Page 2: ...202558 COVANA III Revision 5 2 La version française du manuel débute à la page 21 FRANÇAIS ...
Page 8: ...202558 COVANA III Revision 5 8 FRAME DIMENSIONS AND FOOTPRINT ...
Page 12: ...202558 COVANA III Revision 5 12 Wiring Schematic Diagram 120VAC 60Hz Operator North America ...
Page 13: ...202558 COVANA III Revision 5 13 Wiring Schematic Diagram 220VAC 50Hz Operator Europe Only ...
