4. INSTALL ROUND DUCTWORK
Connect the round ductwork (not included) to the damper/duct connector, and run the
ductwork to a roof or wall cap (not included). Using tape (not included), secure all the
ductwork connections so that they are air tight.
ASSEMBLY INSTRUCTIONS
CONNECT ELECTRICAL WIRING
INSTALL GRILLE
3
Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the
wiring plate. Refer to the wiring diagram, and connect the wires as shown.
The ducting from this fan to the outside of building has a strong effect on the air flow,
noise and energy use of the fan. Use the shortest, straightest duct routing possible for
best performance, and avoid installing the fan with smaller ducts than recommended.
Insulation around the ducts can reduce energy loss and inhibit mold growth. Fans
installed with existing ducts may not achieve their rated air flow.
UNIT
BLACK (BLK)
NIGHT
LIGHT
LIGHT
SWITCH BOX
FAN
120V AC LINE IN
GROUND (GRD)
RED
WHITE (WHT)
BLUE (BLU)
FAN
RECEPTACLE
LIGHT
RECEPTACLE
WIRE
PANEL
Insert the light plug from the grille assembly into the wire panel.Pinch the
grille springs on the sides of the grille, and position the grille into the
housing with the grille springs in the appropriate slots. Push the grille
assembly towards the ceiling to secure.
Remove the lens
Carefully pry out the light lens by inserting a small,flathead screwdriver
between the grille and lens.
Install the light bulbs
Install a 26W max. fluorescent bulb and a 4W incandescent night light
bulb. Replace the lens.
Wire panel
