EXPRESSION AND RAMPING
Fever Pitch will smoothly blend between the two knob settings as you move the
expression pedal. You can map any of the effect knobs to the expression pedal, other
than a few controls that don’t have linear functions like tap division and tremolo mode.
If you prefer to have controls that aren’t affected by the expression pedal, simply set
them with the pedal heel down, then gently “wiggle” the knob with the pedal at toe
down. This will set the same values for heel and toe and those knobs won’t change as
you sweep the pedal.
The MultiJack input is factory-calibrated for most common expression pedal types,
but you can also adjust the range using the configuration menu. Tweak the EXP LO
parameter to set the heel down value and the EXP HI parameter to calibrate the toe
down position.
You can also use the Ramp function to automatically move between expression
positions. Use the RAMP knob to set the speed of the ramp, and the TRIG knob to set
the trigger mode. Hold the Tap / Ramp footswitch to fire the ramp.
TOGG ramp will alternate between positions when you hold the footswitch
MOM ramp will move from heel to toe when you hold the footswitch, and return
when you release it.
REPT ramp will start when you hold the footswitch, and will automatically move
from heel to toe and back until you hold the footswitch again.
Hold the PAGE knob on the MISC page to reset the ramp / expression settings.
Connect a TRS expression pedal to the MultiJack to control any or all of the pedal
parameters remotely.
Fever Pitch requires a TRS expression pedal, sleeve = 0V (common,) ring = 3.3V, tip
= 0-3.3V. You can also use an external control voltage connected to tip and sleeve, as
long as it doesn’t exceed 3.3V.
If you’re using a MIDI controller, you can send MIDI CC 100, value 0-127. 0 is the
same as full heel setting, 127 is toe setting.
To map expression pedal values to pedal settings, first set the expression pedal to the
heel setting then turn the pedal knobs. Then sweep the expression pedal to the toe
setting and turn the knobs again.
1 FEVRPTCH
LVLA
LVLB
LVLC
LVLD
DRY
MAIN
EXP
1 FEVRPTCH
LVLA
LVLB
LVLC
LVLD
DRY
MAIN
EXP
HEEL SETTING
TOE SETTING
STEREO ROUTING
Fever Pitch was designed to work in a stereo context - everything centers (no pun intended)
around its flexible routing and panning controls. We’ll cover how all the various stereo
modes work so you can pick the one that works best with your rig.
To set the stereo mode, enter the setup menu and navigate to STEREO. The pedal will
reconfigure its inputs and outputs as you step through the menu, and once you’ve set it as
you like just hold the PAGE knob to save.
MONO INPUT
Standard mono input.
Use this for mono input with full
stereo output.
input sum
Input is summed L+R from TRS,
output is full stereo.
stereo
Input is stereo from TRS, output is
full stereo.
Use this if the previous device in
chain has stereo output.
MONO I+O
Input is mono, output sets all pan
controls to center for dual mono.
Use this if using the pedal strictly
with one amp, prevents signal loss
with wide pan settings.
sum mono
Input is mono summed from TRS,
output sets all pan controls to
center for dual mono.
Use this if previous device in chain
is stereo but only one amp is
connected.
