9
Card or PIN mode
The pins must be entered within 2 seconds, otherwise the system will be exited.
Press [
*
] to cancel the entered code.
Restore factory default
Press [
86
] . You will hear 2 beeps, after 5 seconds enter to the configuration mode:
Press [
*
] + [
Programming pin
]
PIN Default::
[
*
].
Subsequently, the factory default values will be restored.
Reset programming pin
Remove the control. Use a metal clamp to briefly connect Jumper 2 (J2), the control will emit a beep,
then 2 beeps, and the programming pin will be reset to the factory default (
990101)
.
