Support:
steppir.com/support
⚫
Tel: 425.453.1910
⚫
Page 8
Install the Rain Cap
•
On the tip of the pole you will install the black cap with a piece of tubing passing through
it. The purpose of this vent cap is to keep the rain out, yet still allow air flow through the
foam plug into the telescoping pole.
Warning: Press the cap on approximately
1
-
1/8”
Do NOT press the cap down so hard as to
crimp (damage) the cross tube preventing the pole from properly venting.
Prepare and Install the Solderless Connector
•
Remove the 4 pin solderless connector from inside the EHU.
•
Prepare the 4 conductor control cable by re-
moving
1”
of insulation from the end of the
cable and stripping
1/4”
of insulation from the
ends of each of the wires.
•
Wire the connector Black, Red, Green, White
using the image to the right as a reference.
1.125
Antenna Assembly
Summary of Contents for SmallIR
Page 22: ......