Stephen Technologies Co.,Limited SVG400S IP ADAPTOR User Manual
7
phone to set the IP address.
*09987456
Reset IP:
LAN Port IP:
192.168.0.1 (The new terminal are DHCP
default)
PC Port IP:
192.168.5.1(The new terminal are bridge
mode.)
*11983185922
Reset system configuration. Return to the
default configuration.
Note: These commands are factory preset and cannot be modified.
3.1.2 Star Commands for Phone Operation
The star commands for phone operation are 3-digit long at least and some contains
operands. These star commands are shown in the table below.
Star(*) Command
Function
*12
Switch to VOIP line
*21
Switch to PSTN line
*42
Hold the current call / Release the Hold call
*41
Call Transfer to another VoIP Number
3.2 Set up
The setup of the SVG400S IP ADAPTOR can be done via auto-provisioning if the service
provider supports this feature. Local setup is supported via built-in web pages. To access
the web pages, the LAN or PC port IP address is required. The SVG400S IP ADAPTOR is
equipped with voice prompts to read LAN port and PC port IP addresses via the Phone
port.
Please refer to the table in section 3.1.1 for detailed information. While seting up, please
follow the instructions as follows :
a) When the SVG400S IP ADAPTOR fails to set the LAN Port and PC Port IP addresses,
it reports 0 on *01 or *02 Star Commands.
b) When the PC port is configured into Bridge Mode, it also report zero.
c) *03 and *04 can be dialed to set the LAN Port IP address and PC Port IP address. For
example, if you want to set the PC Port’s IP address to 192.168.5.10, please press
the following keys orderly : “*04192.168.5.10#”. Note : enter Symbol “*” replace “.”
and end with “#”.
d) A special star (*) command (*09987456) can be dialed to reset both LAN port and PC