Step2 Woodland Adventure Playhouse & Slide 4906, Manual

Page: 4 / 76

Protrusion Hazard Sorting Wood
(Example)
If threads are exposed, check for correct
hardware. If overtightened, add washers to
eliminate the protrusion.
Bolt and Barrel Nut Assembly
Insert barrel nut through the lock washer and press
the pair through the provided hole. Insert your bolt
through the second lock washer and insert the pair
into the provided hole opposite from the barrel nut.
Turn clockwise to thread into the barrel nut. Do not
completely tighten until instructed.
LOCK WASHER
LAG SCREW
LOCK WASHER
LOCK WASHER
BOLT
BARREL NUT
T-NUT
LOCK WASHER
BOLT
Bolt and T-Nut Assembly
Tap T-nut into the provided hole. Insert your
bolt through the lock washer and insert into the
provided hole opposite from the T-Nut. Turn
clockwise to thread into T-nut. Do not completely
tighten until instructed.
LOCK WASHER
LAG SCREW
LOCK WASHER
LOCK WASHER
BOLT
BARREL NUT
T-NUT
LOCK WASHER
BOLT
Lag Assembly
Normally there will be a pre-drilled pilot hole on
assemblies that require a Lag Screw. If there is no
pilot hole, line up the two boards as they are to be
attached and use the factory drilled hole as a guide
to drill another pilot hole into the adjoining board.
This will keep the wood from splitting. Only a lock
washer is required for steps with Lag Screws.
LOCK WASHER
LAG SCREW
LOCK WASHER
LOCK WASHER
BOLT
BARREL NUT
T-NUT
LOCK WASHER
BOLT
Assembly TIps
INCORRECT CORRECT
Sorting Hardware
Hardware Identification
When removing the wood from the boxes we recommend arranging them by part number before you begin
assembly. This will allow for faster assembly and easily identify any parts that may be missing or damaged.
To help with assembly we recommend sorting your hardware bags with the seven digit alpha-numeric number printed on the bags or by hardware type
(i.e. bolts, nuts, etc.). Organizing your hardware will make assembly easier.
BARREL NUT
H100545
SCREW
H100695
T-NUT
H100699
WASHER FLAT
H100706
BOLT HEX
H100716
BOLT
H100718
SCREW PWH
H100742
G2
G1
F2
F1
E1
E2
Hardware bags are printed with a seven digit
alpha-numeric part number. During assembly you
only need to reference the last three digits of the
part number as noted in each step. This will make
finding the correct hardware easier.
Proper Hardware Assembly
BOLT WH
5/16 x 1-3/4 -182434 (H100011)
011
011
(x2)
030
(x2)
4