PP500 LED lighting controllers - User Manual
—
4
—
PP500 LED lighting controllers - User Manual
1
Getting started
This user manual describes the setting up and operation of the PP500 and
PP500F lighting controllers. References to the PP500 apply to both
except where noted.
The PP500 is a channel lighting controller that provides 2 Amps
continuously or 10 Amps pulsed. The P500F is the same as the PP500
except the pulse timing can be altered in 1μs steps (refer to
Section 10.2,
Specifications
for more details).
Read
Section 2, Safety
(or
Section 3, Sicherheit
, or
Section 4, Sécurité
)
and , and check the PP500 fulfils your requirements.
Mount the PP500 as described in
Section 6, Mechanical fixing
, using a
DIN rail or the mounting holes. In particular, read the notes on heatsinking
in
Section 7, PP500 heat output
.
Connect the PP500 up to a supply and an LED lighting unit as described in
Section 8, Connections
. When the PP500 powers up, it should show two
alternating lines on the display to indicate that it is operating properly.
Refer to
Section 9, Front panel configuration
to set the PP500 up from its
front panel.
For additional information on the use of the PP500. Visit
www.gardasoft.com
to download a range of Application Notes.
—
5
—
WWW.STEMMER-IMAGING.COM
