STEMBoT 2 User’s Manual
========================================================================
2.2.1.0 Charging the SB2 Battery
Without the charger connector, the SB2 will notify the user of a low battery condition if
the green LED adjacent to the charging connector starts to blink. To charge the SB2 battery,
make sure both the battery and charger are plugged in. Charging will begin automatically,
whether the board is turned on or not. One full charge cycle takes a maximum of 4 hours, and a
completed cycle is indicated by a solid green light on the LED.
2.3.0.0 Remote Controller
The STEMBoT 2 comes with a remote controller for wirelessly operating the robot. The
controller is a standard XBox controller design with custom internal hardware.
2.3.1.0 Pairing the Remote Controller
To pair the remote, navigate to “Tools” on your STEMBoT 2 and then click the B button
to enter into the pairing mode. Next press the sync button on the remote, near to Left-button
bumper. After it says “Successfully paired” you can then drive your bot by selecting the remote
control application.
2.3.2.0 Calibrating the Remote Controller
After successfully pairing, if either of your STEMBoT’s motors are moving on their own,
you can recalibrate your remote by holding the middle green button. Once the red LED flashing
sequence begins, move your joysticks in circular patterns until the LED flashing sequence
finishes.
========================================================================
Revision 1.1.0 : January 2021
Summary of Contents for STEMBoT 2
Page 1: ...User s Manual Rev 1 1 0 ...
