For vehicles with M60 Engine
6.
Disconnect the negative cable from the battery located under the rear
seat.
7.
Remove the four screws that hold the engine top cover trim panel to
intake manifold.
(Figure 22)
8.
Remove the battery "+" terminal mounting bolts, and diagnostic connector
mounting clip. Let these components hang freely.
(Figure 22)
9.
Locate the coolant reservoir and remove the overflow tube. Remove the
reservoir's two securing nuts to gain access to the blower motor access
panel.
(Figure 23)
10.
Carefully remove the black plastic heater valve cover.
(Figure 23)
11.
Remove the four nuts that secure the black metal wire conduit cover to
the blower motor access panel. Now remove the five 7mm screws that hold
the black rubber coated blower motor panel to the bulkhead. Finally pull
the weather seal up.
(Figure 24
)
12.
Remove the blower motor access panel and the black plastic blower
motor shield from the bulkhead cavity. (Figure 25)
8
Fig 22
Fig 23
Fig 24
Fig 25
REV2 5.12.03
bmwstx 8/10
aa
RECIEVER
INSTALLATION GUIDE
automotive security systems
(E-36) 3 Series ( Except 318ti & Z3)
