Page 19
INSTALL_3-RD-GL-R REV A
Align top and base using a plumb bob to
line the bolts on top and the bolts on the
bottom up with each other.
Top must be exactly above the base in
order for the glass to fit properly.
ROUND GLASS INSTALLATION
Glass Place
Install the smaller inner glass by placing
evenly across half of the support with
rubber pads.
DON”T LET GO - glass will tip out!
Secure with clips and wing nuts.
Do not over-tighten wing nuts.
Repeat for the other three panels.
Center
Glass Support
NOTE
When placing the glass, keep the wing nuts
loose until all four pieces of glass are in
place.
After lining the edges up, gently and evenly
tighten the wing nuts.
ONLY TIGHTEN UNTIL SNUG.
Do not over-tighten.
7 - GLASS FRAME ASSEMBLY
Figure 7.1
Figure 7.2
