10
How to Pair Remote
The remote control is paired to the Model P100 at the factory, and you only need to pair it again if you
have a new Model P100 or remote. To pair the RF remote control to a Model P100:
1. Turn on the Model P100.
2. Hold down Play & OK until the remote control´s green LED flashes.
3. Point the remote control at the Model P100 and hold it within 30cm / 1 foot of the front panel;
when the green LED stops blinking, the remote is connected via Zigbee.
4. The remote will be paired to the Model P100.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.
Switching Remote to RF and IR Mode
To switch the remote from RF to IR mode, hold down OK and 1. The LED will flash red twice.
To switch the remote from IR to RF mode, hold down OK and 2. The LED will flash green twice.
Setup Procedure
Set up the Model P100 surround sound processor by following these steps:
1. Check that the mains voltage switch on the A1/A2 amplifiers is correctly set to either 115V or
230V.
2. ID-assign all Model A1/A2 amplifiers via dip-switches on the A1/A2 socket panel according to
the project-specific wiring diagram.
3. Connect speakers to the Model A1/A2 amplifiers.
4. Connect Model A1/A2 amplifiers to the Model P100 as shown in the project-specific wiring
diagram.
5. Connect all external equipment, such as a Blu-ray player or home automation system, to the
Model P100, including inputs, outputs, and mains.
6. Connect power to the Model P100, the amplifiers, and all connected audio and video sources.
7. Switch on the Model P100.
8. Access Installer menu via Web or the remote and OSD.
9. Go to Speaker and room - -> Manage and add the Speaker Configuration file from a USB
stick.
10. Verify speaker setup by going to Speaker and room, select your speaker configuration and
press Right on the remote to select the setup. At the bottom of the screen, select and press
Verify Speakers.
11. Check speaker phases
12. Run RoomPerfect™ Guided Setup.
13. Set up sources, zones, etc.
14. Save and back-up settings.
Summary of Contents for Steinway & Sons P100
Page 1: ...Steinway Sons Model P100 OWNER S MANUAL Version 1 0...
Page 28: ...28...
