32
on the same side of the target as the laser is mounted and must fall within
15 cm of the bore at 25 meters. See Paragraph 3.6.
The DBAL-I
2
is equipped with adjusters to zero the IR POINT and IR ILLUM.
Each adjuster click will move the laser point by 1 cm at 25 meters.
The IR POINT adjuster guards are marked with arrows and the letters U/D
and R/L, indicating the direction that the shot group will move if an adjuster
is turned when the laser is mounted in the horizontal (top) position. The IR
ILLUM adjuster guards are also marked with arrows and the letters U/D and
L/R, indicating the direction that the ILLUM beam will move on the target if
an adjuster is turned when the laser is mounted in the horizontal (top)
position. The adjusters will move the IR POINT approximately 10" or 25 clicks
in each direction from the factory neutral preset position at 25 meters.
See Paragraph 3.5.
Zero the IR POINT first then center the IR ILLUM on the IR POINT.
Summary of Contents for DBAL-I2
