Steiner 75-71215B4, Operations & Parts Manual

Page: 12 / 26

10
CAB
34. Coil excess wire harness and secure using
nylon ties. Make sure to leave enough room for
complete front travel of machine. Avoid any HOT
or MOVING parts.
DO NOT SECURE WIRE
HARNESS TO HIGH PRESSURE FUEL LINES!
35. Reconnect the accessory plug with the two wires
(Red +, Black -) before installing pump cover.
Reinstall the top screws of the pump cover
assembly removed in Step 9. Install lower center
front filler
(Item 3) over the bottom of the pump
cover attach with two .25 x .75 screws (Item 27) .
Figure 25
36. Tip the seat up and install under seat seal filler
assembly (Item 13) textured side up. The
seal will fit over the radial bearing suspension
doughnuts. Figure 26.
37. Lower the seat to normal position to help position
the Velcro into place for the battery box and
fuel tank before removing the liner and applying
adhesive.
38. Peel off the liner on the PSA Velcro strips and
attach to the rear wall of the cab and to the
fenders. Apply pressure to the Velcro to get
good adhesion.
Figure 27 & 28
FIGURE 25
FIGURE 28
FIGURE 27
FIGURE 26
ASSEMBLY