STEINEL IR Micro LiveLink, Information, Page: 8 / 69

- 14 - - 15 -
5. Detection zone
Reliable presence detection depends largely on the number, quality and arrange-
ment of the lens elements. The IR Micro LiveLink - with its high-resolution sensor
system, including multi-segment pyro sensor - provides reliable, precision detec-
tion over 6 × 6 metres. The square detection zone provides the basis for creating
optimum configurations quickly and easily.
6. Technical specifications
presence
radial
tangential
presence
radial
tangential
Dimensions (Ø × D) Ø 80 × 20.5 mm
Power consumption 3 mA / 2-DALI user,
12 - 22.5 V , no SELV
Sensor technology Passive infrared
Switching mode LiveLink box
Detection zone 360° with 90° angle of aperture
(for ceiling lights)
(84 detection beams and 168 detection zones)
Reach Square detection zone installed at a height of 3 m:
presence detection zone approx. 4 m × 4 m
Motion detector approx. 6 × 6 m
Time setting From 1 min to 60 min via LiveLink box
Twilight setting 2 - 1000 lux (via LiveLink box)
IP rating IP20
Temperature range Ambient temperature -25°C to +55°C
7. Troubleshooting
Malfunction Cause Remedy
Light does not switch
ON
L LiveLink box faulty
L Lux setting too low
L No motion being
detected
L Replace LiveLink box
L Slowly increase lux set-
ting until light switches
ON
L Ensure unobstructed
sensor vision
L
Check detection zone
Light does not switch
OFF
L Lux setting too high
L Stay-ON time still effec-
tive
L Interfering heat sources:
e.g. fan heater, open
doors and windows,
pets, light bulb / halogen
floodlight, moving ob-
jects
L Reduce lux setting
L Wait until stay-ON time
elapses; reduce stay-ON
time if necessary
L Use stickers to mask out
stationary sources of
interference
Sensor switches OFF in
spite of persons being
present
L Stay-ON time too short
L Light-level threshold too
low
L Increase stay-ON time
L Change light threshold
Sensor does not switch
OFF quickly enough
L Stay-ON time too long L Reduce stay-ON time
Sensor does not switch
ON quickly enough
when approached from
the front
L Reach is reduced when
approached from the
front
L Install additional sensors
L
Reduce distance be-
tween two sensors
Sensor does not switch
ON when persons are
present despite it being
dark
L Lux setting too low L Sensor deactivated via
switch/button?
L
Semi-automatic mode?
L Increase light-level
threshold
Sensor does not switch
ON selected basic
brightness in spite of it
being dark
L Sensor in semi-automat-
ic mode
L Lux setting too low
L Switch sensor to fully
automatic mode
L Increase light-level
threshold
Other faults L Sensor operating at the
limit of specific tempera-
ture ranges
L See technical specifica-
tions