Connecting the supply lines
Connecting the electrical supply
1. Connect the RCD adapter
C
to the electrical supply that has been prepared at the installation
site.
The electrical supply is now connected.
Connecting a drain line for the condensation water (optional)
1. Insert the drain connection
4
into the hole in the base plate.
2. Push the drain line (garden hose) for the condensation water onto the drain connection
4
.
The drain line for the condensation water is now connected.
Display
Standby mode
When in Standby mode, the heat pump is operationally ready but deactivated. Pressing the
On/Off button
15
switches the heat pump into the Operate mode.
After being switched on, the heat exchanger must first warm up before the heat pump is
ready for operation in the Operate mode. This process can take up to 90 seconds.
Display:
- The Display
14
shows the word “OFF”.
The Operate mode
When in the Operate mode, the heat pump warms up the water to the set water temperature. The
default setting for the water temperature is 27 °C. The value for the water temperature can be set
to a value b15 °C and +35 °C. Pressing the On/Off button
15
switches the heat pump to
the Standby mode. The water temperature can be set as desired by pressing the Up
16
or the
Down
17
button.
After being switched off, the heat exchanger must cool down before the fan stops
running. This process can take up to 90 seconds.
G
Set
14
15
38
Summary of Contents for 049273
Page 2: ...2...
Page 3: ...3 2 1 4 3...
Page 4: ...Set C A B D D 9 5 8 7 6 14 17 15 16 18 POWER RESET TEST 11 12 13 10 5 4 4...
