Steinbach 040310, Original Owner'S Manual

Page: 39 / 305

4. Check the pump for unusual noises.
If there is air in the system, bleed it again.
5. To stop pump operation, pull the power plug.
The pump is switched off.
Care instructions
The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure hygienically clean
water.
- Consult an expert and observe the dosage.
Maintenance
Backflushing
Do not backwash when using Steinbach Filter Balls. If the filter throughput decreases, we
recommend washing the filter balls by hand. If necessary, exchange the filter balls.
1. Switch the pump
3
off by pulling the power plug.
2. Connect the backwash line (see section "Connecting the backwash line").
3. Press and hold down the valve lever
31
on the valve head
1
.
4. Set the valve lever to the "BACKWASH" position and release it.
5. Connect the pump's power plug to the power supply.
6. Backwash the system until clean water emerges from the backwash line (max. 2 minutes).
7. Switch the pump
3
off by pulling the power plug.
8. Press and hold down the valve lever
31
on the valve head
1
.
9. Set the valve lever to the "RINSE" position and release it.
10. Connect the pump's power plug to the power supply.
11. Let the pump run for 20 to 30 seconds to remove any residue in the valve head.
12. Switch the pump
3
off by pulling the power plug.
The backwashing is completed.
Exchanging the filter medium
The filter medium used (quartz filter sand or Steinbach filter balls) should be exchanged
every 2 to 3 years, depending on the operating period and the amount of dirt on the
device.
1. Switch the pump
3
off by pulling the power plug.
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Screw in the drainage opening
24
so that it comes out of the base of the filter vessel
2
.
4. Completely drain the water from the filter vessel
2
via the drainage opening.
5. Screw the drainage opening into the filter vessel.
6. Undo the locking ring
7
by turning the screw counter-clockwise. Use the Allen wrench
22
for this
purpose.
7. Put aside the locking ring and its screws.
8. Slowly turn the filter vessel on its head and discharge the quartz filter sand or the filter balls.
9. Inside the filter vessel, pull the filter arms
9
off the screen
8
.
10. Remove the screen.
11. Thoroughly rinse the screen and the filter arms under flowing water.
12. Rinse the filter vessel with clean water.
13. Carry out steps 4 to 12 as described in the "Preparing the filter vessel" section.
The filter medium is exchanged.
39
en