5
1
1
1a
SCREW M4 X 35
1
1
3
3
2
2
4
4
3
3
3
3
3a
2a
2
2
SCREW M3.5 X 30
Note: Use lubricant on screws that
fasten into top & bottom rails.
Note: Apply a small bead of
silicone at joint as indicated prior
to fully fastening up. Clean off
excess.
1
2
3
Mark out the positioning of the wall profiles (refer to the Layout Plan on page 5 for measurements).
Using a soft pencil or masking tape mark out the outside boundary line on the base and up the walls
with a spirit level. Use the wall channel holes to pre-drill a 2mm lead hole in the lining.
Take the bottom curved horizontal rail (6) and install the two fixed panels (8). NOTE: The screw holes in the
fixed panel profiles are offset. Check that these align with the screw locations in the curved horizontal rails.
If they do not line up, change over the fixed panels. Use 3.5x30 frame screws.
Add the top horizontal rail using the M3.5 x 30 screws fasten this frame together.
INSTALLATION
Prior to wall channel fixing
Apply a continuous 7mm bead
of silicone on back of channel
plus short bead across tray to
liner join at base of channel.
1
