7
INSTALLATION
1
1a
1b
Adjust the sliding doors using the screws
located on the bottom of top roller
assemblies. Adjust rollers so that the
sliding doors are parallel to each other.
Note: Do not over tighten top rollers as
this will cause the bottom rollers to jam
and break
!
Silicone is not used on the inside of the
shower screen because water can build
up over time within the wall channel and
leak out of the shower area. The screen is
designed to allow the water to return into
the shower area, if any is present.
Screens that are sealed on the inside will
void warranty.
!
Allow 24 hours for silicone to fully dry before use.
!
1b
1c
1a
ENSURE THAT THE CHOSEN POSITION IN 1A
AVOIDS DRILLING THROUGH THE GLASS.
!
SCREW M4x10
CHECK FOR LEVEL
VIEW FROM INSIDE
3.2MM
DRILL
BIT.
7
8
9
Adjust the sliding doors as shown in the illustration below.
1. Double check the frame alignment including levelling the top horizontal Rail to ensure that the whole
frame sits square on the shower.
2. From the inside attach the wall channels with M4x10 screws to the fixed glass extrusion.
Apply silicone to outer line as indicated
Seal the join between wall
profile and frame. 150mm
up from base on both sides
