8. Connect water inlet and outlet to the appropriate brass nipples
9. Turn on mains water and check for leaks. Flush the system for 5 minutes at the nearest
garden tap to activate the filter
Notice: The Filter Housing comes with 2 x 1” brass threaded male inlet/outlet and will require
additional fittings to adapt to your plumbing. A shut off valve is recommended prior to Whole
House Filter System
.
This filter housing must be mounted vertically. Make sure it fits comfortably into the location you have
selected for it to be installed and check that there is a suitable connection to cold water supply. The
connection of the filter housing head is 1’ BSP threads
When affixing the mounting bracket to the filter housing head, use only screws provided to avoid
damaging the filter housing head.
Mount the housing with the mounting screws provided. Allow approximately 50mm clearance under the
filter housing for removal of the filter housing to change cartridge
Do not over tighten the filter housing sump to the housing head. Do not use heat torch near the
plastic housing.
1. Shut off the water.
2. Attach the Mounting Bracket to the wall using the supplied Hex Head
Screws and Washers.
3. Attach the Filter System to the Mounting Bracket using the supplied Bolt Head Screws.
4. Lube the O-Ring with clean silicone grease before attaching the cover onto the housing.
Ensure packaging is removed from the filter cartridge.
5. Tighten the Filter Housing using the supplied Filter Wrench (counter clockwise). DO NOT
OVERTIGHTEN OR THE O RING WILL UNSEAT
6. Determine the size of your inlet water supply line. Brass Reducers may be needed to fit
the 1” Filter System
7. Wrap Teflon Tape around the 1” Brass nipples and screw firmly into the filter head.
3
