Congratulations on purchasing your Stefani Whole House Filtration
System. Please read carefully the installation and operation manual
before installing the unit.
IMPORTANT:
Installation must comply with existing State or Local Plumbing codes. Some Plumbing
Codes require installation of this filter system to be carried out by a Licensed Plumber.
.
In
some areas, the water pressure may exceed the system
’
s maximum pressure allowance. If this is
the case, a pressure limiting valve will be required. Please check with your Licensed Plumber during
installation. Install in accordance with AS/NZS 3500.1
Please note to avoid void of warranty the installation shall be in accordance with the Plumbing Code
of Australia. A WaterMark certified backflow prevention device complying with AS/NZS 2845.1 shall
be installed at a first point of entry of a system.
RECOMMENDATION:
If Whole House System has not been used to 2 or more days, you will need
to flush for 5 minutes (to be consistent with the instructions on changing the cartridge before using
the water. If the unit is to be left unused for more than 2 days, the water supply valve must be
turned off.
Slower Flow Rate gives longer contact times for better contaminant reduction
To Maintain a high level of performance and protection provided by the STEFANI water filtration
system, use on STEFANI replacement filter cartridges
HELPFUL HINT:
The life and performance of the filter cartridge may vary, depending on the volume
and quality of the water being filtered. An indication that your filter cartridges may need replacing is
the reduced volume of flow from the faucet, or return of offensive taste and/odour to the filtered water.
We recommend you continue to check for leaks for a day after installation.
INSTALLATION ADVICE:
A water filter system/tap, like any product, has a limited life and may
eventually fail. Also sometimes failure happens early due to unforeseen circumstances. To avoid
possible property damage, this product should be regularly examined for leakage and/or deterioration
and replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak
detector, should be used in those applications where any leakage could cause property damage,
and/or the water supply should be turned off if no one is home/present.
1
CAUTION:
The Whole House Water filtration System should only be used on water that is
microbiologically safe - that is, water that has been adequately chlorinated or disinfected. Additional
sterilising equipment will be required for unsafe water.
The Whole House Water Filtration System is designed to operate at a maximum pressure of Max
Pressure: 1205kpa/175psi - minimum pressure of 69kPa (10psi) and at a maximum Temperature of
40 degree Celsius. Stefani Warrants this filter to be free of defects in material and workmanship for
a period of one year * from the date of purchase (* Warranty period excludes filter cartridges which
are consumable items).
