Your Zip HydroTap will notify you when the filter replacement is due. The change filter light will flash white once per
minute until the filter has been replaced, and the filter percentage will show 0% on the Home screen.
Step 1:
Grab
an empty
bucket
or container to collect the water which will be flushed through the system and
an old towe
l to
mop up any spills.
Step 2:
Open
the
filter access door
on the front of the HydroTap Command Centre. You will see the filter cartridge in front of
you.
Step 3:
Reach to the rear right hand side of the cartridge and you’ll
find
a
flush line (looks like a hose)
which is around
60cm
long
which will be
sealed with a stop cock
located in the centre of the hose.
Place
the free end of the
flush
line
into the empty
bucket
or container.
Turn
the
stop cock
quickly
on then off
to relieve system pressure.
